Universal Remote Control ONE FOR ALL PVR 6 Specifikace stáhnout pdf (Strana 19)

DStv PVR Remote Control Manual

Page 19

Example 2

Programme a macro on the RED button to switch on all the equipment and set the environment for

watching DStv.

Assumptions for this example :

 The TV has been programmed on the Y mode and uses AV connections.

 The home theatre is on X mode.

 The PVR uses input “3” on the home theatre system.

 You are in the TV1 viewing environment.

 The PVR is always on.

 Your favourite channel is 36 (M-Net Series).

1. Check that the dial is on the red mode for TV1 (1A, 1B, 1C or 1D)

2. Press and hold the SHIFT button until the mode window blinks 3 times.

3. Press the WHITE button to indicate that you want to programme a macro. (The mode

window will blink 3 times to indicate acceptance).

4. Press the RED button. (The mode window will blink once to indicate acceptance).

5. Record the macro by using the remote control to do the actions you would like the macro to

perform.

6. Press the number of your favourite DStv channel, in this example, 36 (command 1 and 2 of a

possible 8)

7. Turn the dial to Y for TV mode (command 3)

8. Press the Standby button to switch on the TV (command 4)

9. Wait for the TV to come on then press ALT (in TV mode, ALT = AV) to switch the TV to AV

mode (command 5)

10. Turn the dial to Z for Home Theatre Amp mode (command 6)

11. Press the Standby button to switch on the Amp (command 7)

12. Press 3 to switch the Amp to SAT (the assumed DStv input) – (command 8)

13. Press HELP to terminate the programming mode and save your macro (the mode window

will blink 3 times to indicate successful completion).

14. Optional step – from normal TV viewing, test that the macro you have just programmed

works correctly by pressing SHIFT and then the RED button. You can now put the remote

control down (ensure that it has a clear “view” of the PVR so that it can run the macro).

Note

X It is not necessary to turn the dial back to the PVR mode at the end of the macro, because

the start position for the macro is where the remote control will resume when the macro

terminates.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 59 60

Žádné komentáře

Universal Remote Control ONE FOR ALL PVR 6 Specifikace Strana 19