Universal Remote Control ONE FOR ALL PVR 6 Specifikace stáhnout pdf (Strana 10)

DStv PVR Remote Control Manual

Page 10

Direct set-up

1. Find the 5-digit code for the device from the list provided in this manual (see “Code Tables”

from page 22). If there is more than one code listed for the device, start with the first one

(they are listed in order of probability).

2. Select the mode (X, Y or Z) that you would like to programme to control the other device.

3. Press and hold the SHIFT button until the mode window blinks 3 times.

4. Enter the 5-digit code using the number buttons on the remote control. (The mode window

will blink once after you enter the first 4 numbers and three times after you enter the last

number – confirming that a valid code has been received).

5. This mode can now be used to control the selected device.

Note

X The remote control will indicate an error (two slow blinks in the mode window) and exit the

programming mode if you press anything other than a number button when entering the

device code.

Step-and-set

1. Select the mode (X, Y or Z) that you would like to programme to control the other device.

2. Press and hold the SHIFT button until the mode window blinks 3 times.

3. Enter 991 using the number buttons on the remote control. (The mode window will blink

three times to indicate acceptance).

4. If you are programming the remote to control a TV, press the TV button. If you are

programming the remote to control an amplifier / home theatre system, press the ALT button.

5. Press P+ until the device you are trying to control switches on or off.

6. Press HELP to store this programme and exit the process. (The mode window will blink 3

times to indicate successful completion).

7. This mode can now be used to control the selected device.

Optional Steps

Between steps 5 and 6, you can test other functions of the device you are trying to control (instead

of the power button function). These other functions can be number buttons (0, 1, 2...) volume up,

volume down, mute, and AV. You cannot test programme up (P+) and programme down (P-).

To do this while searching, press the desired function you wish to test (eg. MUTE), and then press

P+ to continue searching. Now each time you press P+, the mute command (instead of the power

on / off command) is sent. This means you continue pressing P+ until the device goes mute

(indicating it recognises the mute command just sent).

Tip

L Once you have completed the steps above, write the programmed codes on the sticker in the

battery compartment for future reference. See “Code Verification” on page 20 if you used the

Step-and-set method to programme your device.

Note

X The P- button can be used to search backwards through the codes if the correct code was

bypassed.

X Scanning of the code database is circular. The mode window will blink 5 times on reaching

the end of the database, but it will stay in the Step-and-set programming mode and start from

the beginning of the database if P+ is pressed again.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Komentáře k této Příručce

Žádné komentáře

Universal Remote Control ONE FOR ALL PVR 6 Specifikace Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Dálková ovládání Universal Remote Control ONE FOR ALL PVR 6