Universal Remote Control omega MX-650 Uživatelský manuál stáhnout pdf (Strana 7)

Universal Remote Control, Inc.

Basic Setup

You can start setting up your Omega using either the Pre-Programmed

Method or the Learning Method. However, all the buttons of the Omega

are setup at once with the Pre-Programmed Method, so it is usually faster

than the one-button-at-a-time Learning Method.

Pre-Programmed Method

Power on the A/V component you wish to setup, so that you can test

codes by sending power off commands.

Refer to the pre-programmed code tables on pages 37 - 52 and

write down the code numbers listed for your A/V component. The

code numbers are listed by categories of devices, then by brand.

See page 37 for a category list. Code tables with model numbers

are available at www

.universalremote.com in the MX-650 area.

Press and hold both the MAIN and ENT (Enter) buttons for approxi-

mately three seconds. The top of the display will show “SETUP”.

You are in SETUP mode now.

Note: You have 30 seconds to perform a step while you are in SETUP mode. If

you don’t press a button within that time, the Omega will time out and return to

normal operation.

MAIN

Button

ENT

Button

1 2 3 4 5 6 7 8 9 10 11 12 ... 59 60

Žádné komentáře

Universal Remote Control omega MX-650 Uživatelský manuál Strana 7