Universal Remote Control CONTROL WR7 Uživatelský manuál stáhnout pdf (Strana 22)

Page 22

IMPORTANT: You have 30 seconds to perform the next step

while you are in programming mode. If you do not press a button

within 30 seconds, the component LED light will turn off. The remote

will exit the programming mode and you will have to start over.

STEP 2: Press the component button you want to turn on and

then the POWER [ON] button; repeat for all other components

in the order you want them to turn on. The component LED lights

will blink once each time you press the POWER [ON] button.

STEP 3: Once you’ve entered all the Power On commands,

press the CHANNEL Up [CH ] button to save your MacroPower

commands. The component LED lights will blink three times to

confirm that the programming has been successfully saved.

SUGGESTION: Most of the components have the same

signal to turn the power On and Off. You may want to program

MacroPower only in the POWER [ON] button and save the

[SYSTEM OFF] button to turn components On or Off individually.

Note: If you want to program MacroPower for the

[SYSTEM OFF] button, repeat the same steps used for

POWER [ON] programming.

COMPONENT

BUTTONS

CHANNEL

POWER

WR7 1/13/08 12:18 PM Page 22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 48 49

Žádné komentáře

Universal Remote Control CONTROL WR7 Uživatelský manuál Strana 22