Universal Remote Control RNC-200 Uživatelský manuál stáhnout pdf

Products: R&S CMU300, NetHawk RNC/Iub Simulator

Testing the Ericsson

Node B Typ RBS 3202

with

R&S

CMU300

BTS Radio Communication Tester

and

NetHawk

RNC/I

Simulator

Testing the RF parameters of a WCDMA base station during the network rollout phase ensures

subsequent trouble-free operation of networks as a basic prerequisite for general UMTS customer

acceptance. This document describes a complete solution for testing the main transmission and reception

parameters according to Specification 3GPP TS 25.141 FDD R99 on the basis of the R&S CMU300 Radio

Communication Tester (RF measurements) and the NetHawk RNC/Iub Simulator (base station controller).

The solution presented here is particularly recommended for installation measurements and regression

tests on new UMTS system components.

1 2 3 4 5 6 ... 15 16

Shrnutí obsahu

Strany 1

Strany 2 - Table of Contents

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 10 Rohde & Schwarz • Carry out modulation analysis. The RMS values of the error vector ma

Strany 3 - 2 Operating Principle

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 11 Rohde & Schwarz • To select the CDP measurement unit use softkeys Code Dom. Power / Uni

Strany 4 - 87654321

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 12 Rohde & Schwarz • Set the starting output level to –70 dBm (Generator Level / Total T

Strany 5 - 4 Test Setup

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 13 Rohde & Schwarz Storing the measurement results You can use the R&S CMU300 to save m

Strany 6 - 5 Test Sequence

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 14 Rohde & Schwarz 7 References [1] 3GPP TS 25.141 Technical Specification, 3rd Generatio

Strany 7

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 15 Rohde & Schwarz 9 Additional Information The solution presented here corresponds to the

Strany 8 - Transmitter measurements

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 16 Rohde & Schwarz Amendment History Version Filename Editor Comments 1.0 1CM56_E R&a

Strany 9

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 2 Rohde & Schwarz Table of Contents 1 Overview ...

Strany 10

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 3 Rohde & Schwarz 2 Operating Principle RF TesterR&S CMU300Node BEricsson RBS3202NetHa

Strany 11 - Receiver test

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 4 Rohde & Schwarz 3 Hardware and Software Requirements Configuration of measurement compon

Strany 12

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 5 Rohde & Schwarz 4 Test Setup Please create the test setup according to the following blo

Strany 13 - Sequence

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 6 Rohde & Schwarz 5 Test Sequence The following description of the test sequence assumes b

Strany 14 - 8 Abbreviations

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 7 Rohde & Schwarz Activation of the RF power can be monitored with the aid of the spectrum

Strany 15 - 10 Ordering Information

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 8 Rohde & Schwarz Transmitter measurements R&S CMU300: • Start the function group 3G U

Strany 16

RBS3202 Test with CMU300 and RNC/Iub SIM 1CM56_E 9 Rohde & Schwarz • softkey Analyzer Settings: Set the DL frequency or channel number to

Komentáře k této Příručce

Žádné komentáře

Universal Remote Control RNC-200 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Sítě Universal Remote Control RNC-200. Testing the Ericsson Node B Typ RBS 3202 with Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Sítě Universal Remote Control RNC-200